Fujitsu PRIMERGY TX120 S3 - Removing the Optical Disk Drive Filler Cover

266 Upgrade and Maintenance Manual TX120 S3
Accessible drives
12.2.1.3 Removing the optical disk drive filler cover
Figure 146: Removing the ODD filler cover
Ê Using a slotted screw driver, pry the ODD filler cover out of its bay and
remove it from its installation bay.
V CAUTION!
Save the ODD filler cover for future use.
Always replace dummy modules into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.