TX120 S3 Upgrade and Maintenance Manual 243
Main memory
10.4.5 Concluding steps
Perform the following procedures to complete the task:
Ê Close the server cover as described in section "Closing the server" on
page 70.
Ê Reconnect the AC power cord to the power supply unit as described in
section "Connecting the server to the mains" on page 73.
Ê Update the system board BIOS to the latest version as described in section
"Updating or recovering the system board BIOS and iRMC" on page 86.
Ê Enable boot watchdog functionality as described in section "Enabling SVOM
boot watchdog functionality" on page 96.
Ê Enable the replaced memory module(s) as described in section "Enabling
replaced components in the system BIOS" on page 96.
Ê Verify if the memory mode has been restored to its original state as
described in section "Verifying the memory mode" on page 98.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 103
To Next Page
Loading...
