286 Upgrade and Maintenance Manual TX120 S3
Accessible drives
12.3.1.6 Concluding steps
Perform the following procedures to complete the task:
Ê Close the front cage as described in "Closing the front cage" on page 68.
Ê Close the server cover as described in section "Closing the server" on
page 70.
Ê Reconnect the AC power cord to the power supply unit.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 103.
Ê Verify if your backup software solution requires additional configuration after
installing, removing or replacing an accessible drive as described in section
"Verifying and configuring the backup software solution" on page 82.
12.3.2 Removing backup drive
12.3.2.1 Required tools
● Preliminary and concluding steps: toolless
● Removing accessible drives:
– Phillips PH2 / (+) No. 2 screw driver
12.3.2.2 Preliminary steps
Before installing an accessible drive, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 79.
Ê Remove any backup medium from the drive.
Field Replaceable Units (FRU)
Average task duration: 10 minutes
To Next Page
Loading...
Need help?
General