EasyManuals Logo

Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

Fujitsu PRIMERGY TX120 S3
440 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #179 background imageLoading...
Page #179 background image
TX120 S3 Upgrade and Maintenance Manual 179
Expansion cards and backup units
9.2.1.5 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For a complete cabling overview, please refer to section "Cabling" on
page 365.
9.2.1.6 Connecting a battery backup unit to the expansion card
Ê If applicable, connect a BBU to the expansion card as described in section
"Installing a BBU" on page 188.
9.2.1.7 Concluding steps
Perform the following procedures to complete the task:
Ê Close the server cover as described in section "Closing the server" on
page 70.
Ê If applicable, connect external cables to the expansion card.
Ê Reconnect the AC power cord to the power supply unit.
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section "Updating RAID controller firmware" on page 91.
Ê In order to configure an expansion card that has been installed or replaced,
the card’s Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section "Enabling Option ROM scan" on
page 92.
Ê Enable boot watchdog functionality as described in section "Enabling SVOM
boot watchdog functionality" on page 96.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 103.
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page 107.

Table of Contents

Other manuals for Fujitsu PRIMERGY TX120 S3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu PRIMERGY TX120 S3 and is the answer not in the manual?

Fujitsu PRIMERGY TX120 S3 Specifications

General IconGeneral
BrandFujitsu
ModelPRIMERGY TX120 S3
CategoryServer
LanguageEnglish

Related product manuals