Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

TX1320 M1 Upgrade and Maintenance Manual 337
Appendix
11
Power-on
indicator
yellow /
orange
flashing
iRMC booting
I After connecting the server to the
mains (power cord plugged in /
after mains failure) the iRMC will
boot. The system cannot be
switched on, until the iRMC boot
sequence is complete. During
this time, the power-on indicator
will flash yellow / orange.
yellow on
Power on delay
I After shutting down, the server
cannot be switched on again right
away. If the On / Off button is
pressed right after shutting down
the server, the power-on indicator
will light up yellow until the delay
period ends and the server will
boot.
Pos. Indicator Status Description

Fujitsu PRIMERGY TX1320 M1 Specifications

General

Processor Sockets	1
Memory Slots	4
Form Factor	Tower
Processor	Intel Celeron
Storage	Up to 4 x 3.5" or 2.5" drives
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
RAID Support	RAID 0, 1, 10
Network Controller	Dual-port Gigabit Ethernet
Operating System Support	Linux