Fujitsu PRIMERGY TX2540 M1 - Installing the New SAS Backplane; Concluding Steps

TX2540 M1 Upgrade and Maintenance Manual 155
Hard disk drives / solid state drives
7.2.8.3 Installing the new SAS backplane
Figure 75: Installing the 2.5-inch HDD SAS backplane
Ê At a slight angle, fit the SAS backplane into the two guides on the HDD cage
(1).
Ê Fold down the SAS backplane (2).
Ê Secure the SAS backplane with the two screws (see figure 73).
Ê Connect the power cable and the SAS cable to the SAS backplane (see
figure 73).
7.2.8.4 Concluding steps
Ê "Installing the system fan holder" on page 75
Ê "Reassembling" on page 62
Ê "Installing a 2.5-inch HDD / SSD module" on page 147 and "Installing a 2.5-
inch HDD / SSD dummy module" on page 151.
I For detailed information on HDD mounting order, refer to section "2.5-
inch HDD / SSD configurations" on page 139.
Ê "Connecting the server to the mains" on page 72
Ê "Switching on the server" on page 73