Figure 106: Installing the 3.5-inch HDD bay top cover (C)
Ê Secure the HDD bay top cover to the chassis with five screws (see blue
arrows).
Ê Secure the intrusion switch holder on the HDD bay top cover with one screw
(see orange arrow).
Ê Connect the cables to the SAS backplane (see figure 98).
7.3.7.4 Concluding steps
Ê "Installing the system fan holder" on page 75
Ê "Reassembling" on page 62
Ê "Connecting the server to the mains" on page 72
Ê "Switching on the server" on page 73
Ê "Installing a 3.5-inch HDD module" on page 170 and "Installing a 3.5-inch
HDD dummy module" on page 173.
I For detailed information on HDD mounting order, refer to section "3.5-
inch HDD configurations" on page 165.
To Next Page
Loading...
