Ê Remove the 8x 2.5-inch HDD front panel.
7.2.9.3 Mounting the second 2.5-inch HDD drive cage
Figure 77: Removing the intrusion switch holder (A)
Ê Remove one screw from the intrusion switch holder as shown.
Figure 78: Removing the intrusion switch holder (B)
Ê Slide back the intrusion switch holder until it disengages from the HDD bay
top cover (1).
Ê Remove the intrusion switch holder (2) and set aside.
Ê Leave the intrusion switch cable connected to the system board.
To Next Page
Loading...
