12.4.2 Removing the defective accessible drive
Ê Remove all cables from the accessible drive.
Ê Remove the accessible drive as described in section "Removing an
accessible drive" on page 306.
12.4.3 Installing the new accessible drive
Ê Install the accessible drive as described in section "Installing an accessible
drive" on page 301.
Ê Reconnect all cables to their original accessible drive connectors as
described in section "Cabling plans" on page 395.
12.4.4 Concluding steps
Ê "Installing the system fan holder" on page 75
Ê "Reassembling" on page 62
Ê "Connecting the server to the mains" on page 72
Ê "Switching on the server" on page 73
Ê "Verifying and configuring the backup software solution" on page 90 (if
applicable)
To Next Page
Loading...
