Fujitsu PRIMERGY TX2540 M1 - Concluding Steps; Replacing Accessible Drives; Preliminary Steps

TX2540 M1 Upgrade and Maintenance Manual 307
Accessible drives and LSD
12.3.4 Concluding steps
Ê "Installing the system fan holder" on page 75
Ê "Reassembling" on page 62
Ê "Connecting the server to the mains" on page 72
Ê "Switching on the server" on page 73
Ê If applicable, "Verifying and configuring the backup software solution" on
page 90
12.4 Replacing accessible drives
12.4.1 Preliminary steps
Ê "Locating the defective server" on page 45
Ê "Removing backup and optical disk media" on page 80
Ê "Verifying and configuring the backup software solution" on page 81
Ê "Shutting down the server" on page 48
Ê "Disconnecting the server from the mains" on page 48
Ê "Getting access to the component" on page 49
I Removing the front cover is not required in order to replace an
accessible drive.
Ê "Removing the system fan holder" on page 74
Upgrade and Repair Unit
(URU)
Hardware: 15 minutes
Tools: Slotted screw driver (for bending in or out accessible drive mounting
brackets)