7.3.6.2 Removing a 3.5-inch HDD module
Ê Remove the HDD module to be replaced from the server as described in
section "Removing a 3.5-inch HDD module" on page 172.
7.3.6.3 Installing a 3.5-inch HDD module
Ê Install the new HDD module into the empty drive bay as described in section
"Installing 3.5-inch HDD modules" on page 168.
7.3.6.4 Concluding steps
Ê "Installing accessible drive and HDD bay covers" on page 69
Ê "Performing a RAID array rebuild" on page 102
7.3.7 Replacing a 3.5-inch HDD SAS backplane
7.3.7.1 Preliminary steps
Ê "Shutting down the server" on page 48
Ê "Disconnecting the server from the mains" on page 48
Ê "Getting access to the component" on page 49
Ê "Removing the system fan holder" on page 74
Ê "Removing 3.5-inch HDD modules" on page 171
Upgrade and Repair Unit
(URU)
Hardware: 15 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
To Next Page
Loading...
