11.3 Removing processors
V CAUTION!
Processors are extremely sensitive to electrostatic discharge and must
be handled with care. After a processor has been removed from its
protective sleeve or from its socket, place it upside down on a
nonconducting, antistatic surface. Never push a processor over a
surface.
11.3.1 Preliminary steps
Ê "Disabling or suspending BitLocker functionality" on page 77
Ê "Disabling SVOM boot watchdog functionality" on page 78
Ê "Shutting down the server" on page 48
Ê "Disconnecting the server from the mains" on page 48
Ê "Getting access to the component" on page 49
Ê "Removing processor heat sinks" on page 290
11.3.2 Removing a processor
I This description applies to the following procedures:
– Removing the second processor (CPU 2) from a dual-processor
configuration
– Removing processors from a defective system board (see section
"Replacing the system board" on page 366)
Ê Remove the desired processor heat sink as described in section "Removing
processor heat sinks" on page 290.
Upgrade and Repair Unit
(URU)
Hardware: 15 minutes
Software: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
To Next Page
Loading...
