EasyManua.ls Logo

Fujitsu PRIMERGY TX2540 M1

Fujitsu PRIMERGY TX2540 M1
422 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX2540 M1
Upgrade and Maintenance Manual 271
Main memory
Ê "Shutting down the server" on page 48
Ê "Disconnecting the server from the mains" on page 48
Ê "Getting access to the component" on page 49
Ê Locate the defective memory module using the onboard Local Diagnostic
LEDs as described in section "Onboard indicators and controls" on
page 410.
10.4.2 Removing the defective memory module
Ê Remove the memory module as described in section "Removing a memory
module" on page 269.
10.4.3 Installing the new memory module
Ê Install the memory module as described in section "Installing a memory
module" on page 267.
10.4.4 Concluding steps
Ê "Reassembling" on page 62
Ê "Connecting the server to the mains" on page 72
Ê "Updating or recovering the system board BIOS and iRMC" on page 85 (if
applicable)
Ê "Switching on the server" on page 73
Ê "Enabling SVOM boot watchdog functionality" on page 96
Ê "Enabling replaced components in the system BIOS" on page 96
Ê "Verifying the memory mode" on page 97
Ê "Enabling BitLocker functionality" on page 101
Ê "Resetting the error status after replacing memory modules or processors"
on page 93

Table of Contents

Other manuals for Fujitsu PRIMERGY TX2540 M1

Related product manuals