Figure 311: Connecting the intrusion switch cable
Ê Run the intrusion switch cable through the cable clamps (see arrows) on the
HDD cage and the cable guide (A).
Ê Connect the intrusion switch cable to the system board connector
"INTRUSION" (see circle).
16.3.4 Concluding steps
Ê "Installing the system fan holder" on page 75
Ê "Reassembling" on page 62
Ê "Connecting the server to the mains" on page 72
Ê "Switching on the server" on page 73
To Next Page
Loading...
