Ê Connect the intrusion switch cable to the system board connector
"INTRUSION" (1) (see section "Cabling plans" on page 395).
Ê Connect the front panel cable to the system board connector
"FRONTPANEL" (2) (see section "Cabling plans" on page 395).
14.6.4 Concluding steps
Ê Reconnect all remaining cables to the system board. For a complete cabling
overview, please refer to section "Cabling plans" on page 395.
Ê Reinstall all remaining system board components as shown in the related
sections:
– Heat sinks: refer to section "Installing processor heat sinks" on page 288
– Memory modules: refer to section "Installing a memory module" on
page 267
I Install all memory modules into their original slots.
– Expansion cards: refer to section "Installing a memory module" on
page 267
I Install all expansion cards into their original slots.
– UFM (if applicable): refer to section "Installing the UFM" on page 345
– TPM (if applicable): refer to section "Installing the TPM" on page 352
Ê If applicable, reinstall the rear fan as described in section "Installing the rear
fan" on page 209.
Ê "Installing the system fan holder" on page 75
Ê "Reassembling" on page 62
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility reference manual.
Ê "Connecting the server to the mains" on page 72
Ê "Updating or recovering the system board BIOS and iRMC" on page 85
Ê Reconnect all external cables.
To Next Page
Loading...
