9.5.7.1 Preliminary steps
Ê "Locating the defective server" on page 45
Ê "Disabling SVOM boot watchdog functionality" on page 78
Ê "Shutting down the server" on page 48
Ê "Disconnecting the server from the mains" on page 48
Ê "Getting access to the component" on page 49
9.5.7.2 Removing the defective FBU
Ê Remove the FBU as described in section "Removing the FBU" on page 257.
9.5.7.3 Installing the new FBU
Ê Install the FBU as described in section "Installing the FBU" on page 250.
9.5.7.4 Concluding steps
Ê "Reassembling" on page 62
Ê "Connecting the server to the mains" on page 72
Ê "Switching on the server" on page 73
Ê If applicable, "Updating RAID controller firmware" on page 88
Ê "Enabling SVOM boot watchdog functionality" on page 96
To Next Page
Loading...
