Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section "Removing a slot bracket" on
page 224.
9.4.3.3 Installing the new expansion card
Ê If applicable, install a slot bracket on the new expansion card as described
in section "Installing a slot bracket" on page 220.
Ê Install the expansion card as described in section "Installing expansion
cards" on page 231.
9.4.3.4 Concluding steps
Ê "Reassembling" on page 62
Ê Reconnect all external cables to the replaced expansion card.
Ê "Connecting the server to the mains" on page 72
Ê "Enabling replaced components in the system BIOS" on page 96
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section "Looking up changed MAC / WWN addresses"
on page 103.
Ê "Updating the NIC configuration file in a Linux environment" on page 100
Ê "Updating RAID controller firmware" on page 88
Ê "Enabling SVOM boot watchdog functionality" on page 96
Ê "Switching on the server" on page 73
Ê "Enabling BitLocker functionality" on page 101
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I Configuration of network settings should be performed by the
customer.
For further information, please refer to section "Note on network
settings recovery" on page 239.
Ê If applicable,"After replacing / upgrading LAN controllers" on page 105.
To Next Page
Loading...
