Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

TX2540 M1 Upgrade and Maintenance Manual 263
10 Main memory
Safety notes
V CAUTION!
● Do not install unsupported third party memory modules. For further
information on supported memory modules, refer to section "Basic
information" on page 264.
● Memory modules remain hot after shutdown. Wait for components to
cool down before installing or removing memory modules to prevent
burns.
● Do not insert and remove memory modules repeatedly. Doing so may
cause failures.
● Pressing out the securing clips on the memory slot will eject the
installed memory module. To prevent damage and injuries eject
memory modules carefully without applying excessive force.
● For further information, please refer to chapter "Important
information" on page 33.

Fujitsu PRIMERGY TX2540 M1 Specifications

General

Processor socket	-
Intel Xeon series	E5-2400
Built-in processor	No
Motherboard chipset	Intel® C602
Number of processors supported	2
Number of DIMM slots	12
Supported memory types	DDR3-SDRAM
Maximum internal memory	192 GB
RAID levels	0, 1, 10
Hot-swap HDD bays	Yes
Storage drive sizes supported	3.5 \
Number of storage drives supported	4
Supported storage drive interfaces	Serial ATA, Serial Attached SCSI (SAS)
LAN controller	Intel I210
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
USB 2.0 ports quantity	6
Chassis type	Tower
Product color	Black