Optimizing the Image
5-46 LOGIQ 7 Online Help
Direction 2392536-100 Rev. 1
Generating a Trace (continued)
Moving a dynamic
anchored sample
area
1. Press Scan Area until the scroll trackball assignment is
selected.
2. Using the Trackball, browse throught the cineloop to
display one of the frames where the sample area was
anchored.
NOTE: In these frames, the sample area is marked with an anchor.
3. Press Scan Area until the QA trackball assignment is
selected.
4. Move the cursor to the sample area using the Trackball.
5. Press Set. The sample area is unanchored.
6. Drag the sample area to a new location.
7. Press Set to anchor the sample area to the new location.
Zooming in the
Analysis window
To zoom:
1. In the Analysis window, press and hold down the Set key
while dragging the cursor to define the zooming area.
2. Release the Set key.
To unzoom:
1. Press the left Set key in the Analysis window. The system
menu displays.
2. Select Unzoom.
To Next Page
Loading...
Need help?
General
