Imaging Presets
LOGIQ 7 Basic User Manual 16-41
Direction 2392206-100 Rev. 1
Changing imaging presets
To change imaging presets:
1. On the Touch Panel, select Utility.
2. On the Touch Panel, select Imaging.
The system displays the Imaging screens. See the Imaging
screens on the following pages.
3. In the Preset list, select the exam.
4. In the Probe list, select the probe.
5. In the row across the top of the screen, select the mode.
The system displays two sets of parameters and settings.
The left column lists all settings for the exam (for example,
Abdomen). The right column lists settings that apply only to
the exam and probe combination.
6. To change a parameter, do one of the following:
• Select the value from a list
• Select one value from a choice of two or more buttons
• Select or clear a check box
7. After changing the parameters, to save the changes, select
the Save button.
NOTE: When you Save changes to imaging parameters, the system
saves changes to all modes, not just the mode currently
displayed.
NOTE: If you have problems with imaging, you can return parameters
back to the original settings. Select the exam, probe, and mode,
and then select Reload Factory Defaults. The system returns the
selected parameters to the original settings.
For information about the specific parameters, refer to Chapter 5
Optimizing the Image.
To Next Page
Loading...
Need help?
General
