Abdomen and Small Parts
8-2 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
Abdomen/Small Parts Exam
Preparation
Introduction
Measurements and calculations derived from ultrasound images
are intended to supplement other clinical procedures available
to the attending physician. The accuracy of measurements is not
only determined by the system accuracy, but also by use of
proper medical protocols by the user. When appropriate, be sure
to note any protocols associated with a particular measurement
or calculation. Formulas and databases used within the system
software that are associated with specific investigators are so
noted. Be sure to refer to the original article describing the
investigator's recommended clinical procedures.
Calculation formulas are available in the Advanced Reference
Manual.
General Guidelines
New Patient information must be entered before beginning an
exam. See ‘Beginning a New Patient’ for more information.
Any measurement can be repeated by selecting that
measurement again from the Touch Panel.
To Next Page
Loading...
Need help?
General
