System Positioning/Transporting
LOGIQ 7 Basic User Manual 3-27
Direction 2392206-100 Rev. 1
Transporting the System
Use extra care when transporting the system using vehicles. In
addition to the instructions used when moving the system (See
‘Moving the System’ for more information.), also perform the
following:
1. Only use vehicles that are designed for transport of the
LOGIQ 7 system.
2. Load and unload the system to a vehicle parked on a level
surface.
3. Ensure that the transporting vehicle can handle the weight
of the system plus the passengers.
4. Ensure that the load capacity of the lift (a minimum of 225 kg
[496 lbs] is recommended) is capable of handling the weight
of the system.
5. Ensure that the lift is in good working order.
6. Secure the system while it is on the lift so that it cannot roll.
Use either wood chocks, restraining straps, or other similar
types of constraints. Do not attempt to hold it in place by
hand.
NOTE: Strap the system below its handle so that the system does
not break loose.
7. Employ two to three persons to load and unload safely from
a vehicle.
WARNING
Never ride on the lift with the system. A person's weight
coupled with the weight of the system may exceed the load
capacity of the lift.
To Next Page
Loading...
Need help?
General
