OB/GYN
9-70 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
OB Table Editor
You can add user programmable OB tables to the system.
OB Table Settings Menu
You add OB Tables in the Measurement & Analysis menu. To
open the menu:
1. On the Touch Panel, select Utility, then select M&A.
2. Check the Exam Category on the far left of the monitor
screen. Make sure that Obstetrics is selected.
If it is not selected, select Obstetrics and continue selecting
the folders until the appropriate area is selected as to where
this new OB Table will be entered. For example, select
Obstetrics, then select OB-2/3. If there are further folders
within OB-2/3, select that appropriate folder.
To Next Page
Loading...
Need help?
General
