Measurement and Calculation Setup
LOGIQ 7 Basic User Manual 7-33
Direction 2392206-100 Rev. 1
Changing Measurements
You can make changes to some of the measurements. For
example, Head Circumference can be measured with an ellipse,
a trace, or two distances. You can specify which measurement
type you want the system to use as the default. You specify the
measurement type by selecting the tool to use to make the
measurement.
• To change the tool used to make a measurement:
In the Measurement section of the Measurement & Analysis
screen, select the desired tool from the Tool list. See
Figure 7-18. Select the arrow to display the drop-down list.
NOTE: If the Tool field is gray, it cannot be changed.
After you choose the tool, this is what the system expects
when you scan and choose this measurement.
NOTE: The diagram to the right of the Tool list shows the measurement
type. In Figure 7-18, ellipse is selected and the diagram shows
an ellipse.
To Next Page
Loading...
Need help?
General
