Scanning/Display Functions
6-2 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
Zooming an Image
Introduction
Zoom is used to magnify a zoom region of interest (ROI). The
system adjusts all imaging parameters accordingly. You can also
zoom frozen images.
Zoom
Bioeffect
Zooming an image changes the frame rate which tends to
change thermal indices. The position of the focal zones may
also change which may cause the peak intensity to occur at a
different location in the acoustic field. As a result, the MI may
change.
To zoom an image, adjust Zoom. A reference image appears in
the upper, left-hand section of the display.
To exit zoom, adjust Zoom until the reference zoom image is
removed or press B-Mode.
coust
c
Output
Hazard
Observe the output display for possible effects.
To Next Page
Loading...
Need help?
General
