Scanning/Display Functions
6-4 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
Freezing an Image
Introduction
Freezing a real-time image stops all movement and allows you
to measure and print the image.
You can also freeze the image during VCR playback.
NOTE: While the image is frozen, all Power Output is suspended.
NOTE: Selecting a new probe unfreezes the image
Freezing an image
To freeze an image,
1. Press Freeze. The key backlights.
If you are in a mixed mode, both screen formats stop
immediately. Deactivating Freeze restarts both modes and
places a black bar on the trace to indicate the time discontinuity.
To reactivate the image,
1. Press Freeze again.
NOTE: Deactivating Freeze erases all measurements and calculations
from the display (but not from the worksheet).
Use the Trackball to start CINE after pressing Freeze.
To Next Page
Loading...
Need help?
General
