User Maintenance
18-10 LOGIQ 7 Online Help
Direction 2392536-100 Rev. 1
System Care and Maintenance
Overview
Refer to Section 10 of the LOGIQ 7 Service Manual for any
additional maintenance guidance.
Contact the local Service Representative for parts or periodic
maintenance inspections.
Inspecting the System
Examine the following on a monthly basis:
• Connectors on cables for any mechanical defects.
• Entire length of electrical and power cables for cuts or
abrasions.
• Equipment for loose or missing hardware.
• Control panel and keyboard for defects.
• Casters for proper locking operation.
CAUTION
To avoid electrical shock hazard, do not remove panels or
covers from console. This servicing must be performed by
qualified service personnel. Failure to do so could cause
serious injury.
Biological
Hazard
If any defects are observed or malfunctions occur, do not operate the
equipment but inform a qualified service person. Contact a Service
Representative for information.
To Next Page
Loading...
Need help?
General
