General Measurements and Calculations
7-92 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
Auto vs. Manual Calculations
The same calculations can be performed using either manual or
auto calcs.
Auto Calcs
To perform auto calcs:
1. Ensure that the auto calcs function is on by choosing Auto
Calcs -> Frozen or Live on the PW tab of the Touch Panel.
2. After obtaining a waveform, press Measure. Choose the
appropriate vessel folder or calculation. The system walks
you through the measurements.
To modify auto calcs:
1. Select Modify Auto Calcs on the Touch Panel.
2. Choose the measurements to be performed with this preset.
3. To save these measurements:
• If this is a temporary change, press Return.
• If this is a permanent change, select Save as default.
The measurements are saved and can be performed with
the auto calcs function.
Manual Calcs
To perform manual calcs:
1. To turn Auto Calcs off and perform manual measurements,
choose Auto Calcs -> OFF on the PW tab of the Touch
Panel.
2. After obtaining a waveform, press Measure. Choose the
appropriate vessel folder or calculation. The system walks
you through the measurement.
NOTE: To program which calculations are done under manual calcs
when using measurement folders for measuring specific
vessels, press the Utility key. Select Measure -> Doppler and
program your manual calcs (Auto Calcs OFF). Each vessel must
be programmed individually and saved after each change.
To Next Page
Loading...
