User Maintenance
18-12 LOGIQ 7 Online Help
Direction 2392536-100 Rev. 1
Cleaning the system
Prior to cleaning any part of the system:
1. Turn off the system power. If possible, disconnect the power
cord. See ‘Power Off’ for more information.
System Cabinet
To clean the system cabinet:
1. Moisten a soft, non-abrasive folded cloth with a mild,
general purpose, non-abrasive soap and water solution.
2. Moisten a soft, non-abrasive folded cloth.
3. Wipe down the top, front, back, and both sides of the system
cabinet.
NOTE: Do not spray any liquid directly into the unit.
Monitor
To clean the monitor face:
Use a soft, folded cloth and a glass cleaner solution. Apply the
glass cleaner to the cloth. Gently wipe the monitor face.
Do NOT use a glass cleaner that has a hydrocarbon base (such
as Benzene, Methyl Alcohol or Methyl Ethyl Ketone) on monitors
with the filter (anti-glare shield). Hard rubbing will also damage
the filter.
NOTE: When cleaning the monitor, make sure not to scratch the
monitor.
Operator Controls
To clean the operator control panel:
1. Moisten a soft, non-abrasive folded cloth with a mild,
general purpose, non-abrasive soap and water solution.
2. Wipe down operator control panel.
3. Use a cotton swab to clean around keys or controls. Use a
toothpick to remove solids from between keys and controls.
NOTE: When cleaning the operator control panel, make sure not to spill
or spray any liquid on the controls, into the system cabinet, or in
the probe connection receptacle.
NOTE: In case of SARS, use bleach, alcohol, or Cidex in a normal
diluted form for cleaning/disinfecting the operator panel.
To Next Page
Loading...
Need help?
General
