General Measurements and Calculations
7-2 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
Introduction
Measurements and calculations derived from ultrasound images
are intended to supplement other clinical procedures available
to the attending physician. The accuracy of measurements is not
only determined by system accuracy, but also by the use of
proper medical protocols by the user. When appropriate, be sure
to note any protocols associated with a particular measurement
or calculation. Formulas and databases used within the system
software that are associated with specific investigators are so
noted. Be sure to refer to the original article describing the
investigator's recommended clinical procedures.
Overview
This section provides information about taking measurements
and describes calculations available in each mode. It includes
the following topics:
• Exam workflow
• Location of measurement controls
• Description of calipers
• List of generic measurements
• General information about taking measurements
• Mode Measurements: Step-by-step instructions for taking
specific measurements, organized by mode
• Basic steps to view and edit worksheets
To Next Page
Loading...
Need help?
General
