Preparing the System for Use
3-26 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
When moving the system
1. Always use the rear handle grips to move the system.
2. Take extra care when moving the system long distances and
on inclines. Ask for help if necessary.
Avoid ramps that are steeper than ten degrees to avoid
tipping over the
system.
NOTE: Wheel chair ramps are usually less than five degrees.
Utilize additional care and personnel when moving on steep
incline (>5°) or loading into a vehicle for transport.
3. Use the foot brake (pedal), located on the bottom of the
system in the front, when necessary.
4. Do not let the system strike walls or door frames.
5. Use extra care when crossing door or elevator thresholds.
6. Once the destination is reached, lock the wheels.
CAUTION
DO NOT attempt to move the console using any cables or
fixtures, such as the probe connectors.
CAUTION
The system weighs approximately 225 kg (496 lbs). To avoid
possible injury and equipment damage:
• Be sure the pathway is clear.
• Limit movement to a slow careful walk.
• Use two or more persons to move the system on inclines or
long distances.
To Next Page
Loading...
Need help?
General
