Optimizing M-Mode
LOGIQ 7 Online Help 5-67
Direction 2392536-100 Rev. 1
Anatomical M-Mode (continued)
Adjusting Use the Touch Panel control and Trackball to position the
M cursor over the required area of the B-Mode image.
• Turn the Touch Panel control left or right to move the M
cursor to the desired area.
• Move the Trackball left/right to move the cursor line left/right.
• Move the Trackball up/down to move the M cursor up/down.
Values On/Off.
Benefits Color Flow Mode and Color M-Mode are Doppler Modes
intended to add color-coded qualitative information concerning
the relative velocity and direction of fluid motion within the B-
Mode or M-Mode image.
Bioeffects Changing the Sweep Speed, Packet Size, Frame Rate/
Resolution, Zoom, PRF, and ROI size may change the TI and/or
MI. Observe the output display for possible effects.
To Next Page
Loading...
Need help?
General
