Annotating an Image
LOGIQ 7 Basic User Manual 6-17
Direction 2392206-100 Rev. 1
Body Patterns (continued)
Select the desired body pattern on the Touch Panel. The
selected body pattern is displayed on the monitor.
Press the Move Pattern control on the Touch Panel to
reposition the body pattern with the Trackball and Set controls.
A probe mark is associated with the body patterns and illustrates
the probe position on the body pattern. This marker can be
placed with the Trackball and rotated with the Body Pattern
control.
The probe mark type is selectable by rotating the Probe Type
control on the Touch Panel. There are different choices available
with one being a blank selection.
To select the active side in dual B-Mode, use the Active Side
rotary control at the bottom of the Touch Panel.
Press the Body Pattern/Ellipse control to erase the body
pattern. The pattern is erased and the system exits the body
pattern mode.
Press Set on the keyboard or Scan on the Touch Panel to exit
without erasing the body pattern.
To Next Page
Loading...
