Measurement and Calculation Setup
LOGIQ 7 Basic User Manual 7-17
Direction 2392206-100 Rev. 1
Selecting an exam category
When you open the Measurement & Analysis screen, it displays
the exam category that was last used on the system. To select
the exam category you want to work with:
1. Move the Trackball to highlight the exam category at the
top of the Selection menu.
2. Press Set.
The system displays a list of exam categories.
3. Move the Trackball to highlight the exam category you
want.
4. Press Set.
The Selection menu lists studies and measurements for the
selected exam category.
Figure 7-5. Select Exam Category
To Next Page
Loading...
