Generic Measurements
LOGIQ 7 Basic User Manual 7-79
Direction 2392206-100 Rev. 1
Angle
This function measures the angle between two intersecting
planes.
1. From the Generic Touch Panel, select Angle.
The system displays an active caliper.
2. To position the caliper, move the Trackball.
3. To fix the position of the first caliper, press Set.
The system displays a second active caliper.
4. To position the second caliper at the apex of the angle,
move the Trackball.
5. To fix the position of the second caliper, press Set.
The system displays a third active caliper.
6. To position the third caliper, move the Trackball.
7. To complete the angle measurement, press Set.
The system displays the angle in the Results Window.
NOTE: To rotate through and activate previously fixed calipers, adjust
the Cursor Select control.
To Next Page
Loading...
Need help?
General
