OB/GYN
9-36 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
To select OB/GYN vessel measurements
OB/GYN Vessel measurements use the auto sequence feature.
With this feature, when you select a folder for the vessel you
want to measure, the system automatically starts the first
measurement. It then continues with each of the other
measurements in that study.
1. Select the folder for the vessel you want to measure.
The system shows all the measurements for that vessel.
The caliper for the first measurement is automatically
displayed.
2. Make the measurement.
After you complete each measurement, the system starts
the next measurement. After the last measurement is
complete, the system returns to the OB/GYN Vessel Touch
Panel.
Your system is set up to show the measurements that you
usually make for each vessel. To make a measurement that is
not shown for the selected vessel:
1. Select the folder for the vessel you want to measure.
2. Select Show All.
The system display all possible vessel measurements.
3. Select the desired measurement.
The following pages describe the steps to make each specific
measurement in the OB/GYN Vessel study.
To Next Page
Loading...
Need help?
General
