GYN Measurements
LOGIQ 7 Basic User Manual 9-95
Direction 2392206-100 Rev. 1
Ovary length, width, and height
You can measure the length, width, and height of the left and
right ovaries. Each measurement is a typical distance
measurement made in the appropriate scan plane.
Typically, length and height are measured on the saggital plane
while the width is measured on the axial/transverse plane.
To measure ovarian length, width, or height:
1. Scan the patient's right or left ovary in the appropriate plane.
2. To select left or right, adjust the Side knob.
3. Select the OV folder, then select OV L, OV W, or OV H.
4. Perform a standard distance measurement:
a. To position the active caliper at the start point, move the
Trackball.
b. To fix the start point, press Set.
The system fixes the first caliper and displays a second
active caliper, if preset accordingly.
c. To position the second active caliper at the end point,
move the Trackball.
A dotted line connects the measurement points.
d. To complete the measurement, press Set.
The system displays the distance value in the Results
Window. After the first and second measurement, the
system displays an active caliper for the next
measurement.
5. To make the second and third distance measurements,
repeat steps 3–4.
After you complete the length, width, and height
measurements, the system displays the ovarian volume in
the Results Window.
To Next Page
Loading...
Need help?
General
