Cardiology
10-78 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
Worksheet information
The information on the cardiac worksheet is as follows:
• Parameter – This column lists the mode, the measurement
folder, and the specific measurement.
• Value – The measured value. If more than one
measurement was made for an item, the system uses the
specified method (average, maximum, minimum, or last) to
determine this value.
• m1–m6 – Up to six measurement values for each item. If
you make more than six measurements, the worksheet uses
the last six.
• Method – When there is more than one measurement for an
item, this specifies the method used to calculate the
measurement value listed in the Value column. Choices are
average, maximum, minimum, or last. To change the
method:
a. Move the Trackball to the Method field.
b. Press Set.
c. Move the Trackball to select from the list.
d. Press Set.
For more information about working with worksheets, See
‘Viewing and Editing Worksheets’ for more information.
To Next Page
Loading...
