GE LOGIQ 7 Basic User Manual

Urology Calculations
LOGIQ 7 Basic User Manual 12-5
Direction 2392206-100 Rev. 1
Bladder Volume
This calculation uses a standard distance measurement. Length
is typically measured in the sagittal plane. Width and height are
measured in the axial plane.
Figure 12-2. Bladder Volume Touch Panel
To measure Bladder Volume:
1. Scan the patient in the appropriate scan plane.
2. Select the Bladder folder, an active caliper displays.
3. Perform a standard distance measurement.
The system displays the distance value in the Results
Window.
4. To make the second and third distance measurement,
repeat steps 2–3.
After you complete the third distance measurement, the
system displays the bladder volume in the Results Window.

GE LOGIQ 7 Specifications

General

Brand	GE
Model	LOGIQ 7
Category	Medical Equipment
Language	English