Customizing Your System
16-104 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
Users (continued)
Creating a user
1. Press New.
2. Type the user ID. ENSURE that you DO NOT include the
following characters in a user’s ID: slash (/), dash (-),
asterisk (*), question mark (?), an underscore (_), or blank
spaces. Also, DO NOT set up a user with the same intitials/
signifier.
3. Type the user’s information in the Identity section.
4. Select the user’s group(s).
5. If the user needs full configuration and advanced operations
access, select Admin.
6. Press Save.
Changing a user configuration
1. Move the Trackball to a user ID in the User List.
2. Make the desired changes.
Deleting a user
1. Move the Trackball to a user ID in the User List.
2. Select Remove.
The user is removed from the User List.
To Next Page
Loading...
