Hitachi WJ C1 Series User Manual

Appendix
A-1-14
A.1.4 Data Copy from WJ200 to WJ-C1
 When copying parameter settings from WJ200 to WJ-C1, the following methods are available:
(a) Copy data using the optional remote operator WOP.
(b) Copy data using the inverter configuration software ProDriveNext.
(c) Set manually referring to the parameter list of WJ200 and WJ-C1.
 WJ-C1 is designed to be upwardly compatible with WJ200 Ver3.2. If WJ200 version to be copied
is older than Ver 3.2, additional parameters associated with the upgrade are not copied.
For detailed information such as additional parameters, refer to the "WJ200 Series Instruction
Manual (NT325DX or later)" and set them individually for WJ-C1 as required.
 After copying the data, be sure to check that there is no problem with the operation of the
system.
 The setting range of some parameters of WJ-C1 have been extended for functional
enhancements. It is not possible to copy data from WJ-C1 to WJ200 when the settings are
specific to WJ-C1.
■ Copying parameter/EzSQ data by the remote operator WOP
 The remote operator WOP can read/write setting data and EzSQ program in batch mode in
addition to normal monitor displays and data settings.
 Refer to "Remote Operator WOP Instruction Manual (NT214*X)" for more information.
■ Copying parameter data by ProDriveNext
 In the inverter configuration software ProDriveNext, the setting data of the inverter and EzSQ
program can be uploaded from an inverter as a file in CSV format that can be downloaded to the
inverter.
 Refer to "Inverter Configuration Software ProDriveNext User's Guide (NT8001*X)" for more
information.
A
!
WJ200
WJ-C1
WOP
ProDriveNext
Save as CSV file
Parameter
read
Parameter
write

Hitachi WJ C1 Series Specifications

General

Brand	Hitachi
Model	WJ C1 Series
Category	Inverter
Language	English