Hitachi WJ C1 Series

Chapter 9 Inverter Functions
9-13-5
9.13.5 Outputting a Signal by Combining Two Output Signals
 How to create my own output signals by combining output terminal functions?
 Since logical operations of output signals can be performed inside the inverter, various signals
can be output by combining the operation of output terminal functions.
 There are three types of logical operators that can be selected: logical conjunction (AND),
logical disjunction (OR), and exclusive disjunction (XOR).
 All output signals are covered. However, the logical operation results ([LOG1] to [LOG3]) cannot
be used as the operation target.
Code
Item
Description
Data
[C142]
[C145]
[C148]
LOG1 to LOG3
operand-1 selection
Selects logical operation target 1.
00 to 62
(except 33 to 35, 63, no)
[C143]
[C146]
[C149]
LOG1 to LOG3
operand-2 selection
Selects logical operation target 2.
[C144]
[C147]
[C150]
LOG1 to LOG3
logical calculation
selection
The AND operation (logical conjunction) of
target 1 and target 2 is output.
00
The OR operation (logical disjunction) of
target 1 and target 2 is output.
01
The XOR operation (exclusive disjunction) of
target 1 and target 2 is output.
02
[C021]
[C022]
[C026]
Output terminal
function
Logic operation result 1 to 3 ([LOG1] to [LOG3]):
Performs logical operations on the output
signals selected by logical operation target 1
and logical operation target 2, and outputs
the results.
33
34
35
Q
A
!