Hitachi WJ C1 Series - Page 492

Appendix
A-4-3
L
L terminal ....................................................................... 5-4-1
LAC ................................................................................. 9-3-7
LAD cancel..................................................................... 9-3-7
LAD frequency.............................................. 9-16-5, 9-16-7
LD rating ........................................................................ 8-1-2
Life assessment monitor ........................................... 10-3-3
Life warning output ................................................... 16-2-5
Linear accel/decel ........................................................ 9-3-5
LOC .............................................................................. 9-11-4
LOG1 to LOG3 ........................................................... 9-13-5
Logic operation result ............................................... 9-13-5
Low current signal ..................................................... 9-11-4
Low duty rating ............................................................. 8-1-2
M
Main circuit terminal .................................................... 5-2-1
Maintenance/inspection .......................................... 16-1-1
Major failure signal .................................................... 9-11-2
Manual torque boost .................................................... 9-5-5
Maximum frequency ..................................................... 8-1-5
Megger🄬 test ............................................................. 16-2-3
MI1 to MI7 .................................................................. 12-2-3
Minimum frequency ..................................................... 9-7-1
MJA .............................................................................. 9-11-2
MO1 to MO3 .............................................................. 12-2-3
Modbus communication ........................................... 11-1-1
Modbus communication error ................................. 11-1-2
Modbus mapping ....................................................... 11-3-1
Motor constant .......................................................... 8-1-13
Motor hunting .............................................. 9-5-10, 9-5-12
Multi speed .................................................................... 9-2-7
Multistage positioning ................................ 9-14-1, 9-14-5
N
ND rating ....................................................................... 8-1-2
NDc.............................................................................. 11-1-1
Negative LED [-] ............................................................ 7-1-1
Normal duty rating........................................................ 8-1-2
O
OD .................................................................................. 9-8-2
OHF ............................................................................. 9-11-6
OL ................................................................................ 9-11-3
OL2 .............................................................................. 9-11-3
OLR ................................................................................. 9-9-2
ONT ............................................................................. 9-11-9
OPO ............................................................................. 9-16-3
ORG ............................................................................. 9-14-8
ORL .............................................................................. 9-14-8
Other displays ............................................................ 15-3-2
OTQ ................................................................................ 9-6-4
Output current monitor ............................................ 10-1-2
Output frequency monitor........................................ 10-1-1
Output frequency scale conversion monitor ......... 10-1-1
Output terminal monitor ........................................... 10-2-1
Output terminal NO/NC ........................................... 9-16-1
Output terminal off-delay time ................................ 9-16-4
Output terminal on-delay time ................................ 9-16-4
Output torque monitor ............................................. 10-1-4
Output voltage gain ...................................................... 8-1-5
Output voltage monitor ............................................ 10-1-6
Overcurrent suppression ............................................. 9-9-3
Overload restriction ..................................................... 9-9-1
Overload warning notice .......................................... 9-11-3
Overspeed error ......................................................... 9-5-16
Over-torque ................................................................... 9-6-4
Overvoltage suppression ............................................. 9-9-4
Overvoltage/overcurrent retry ................................. 9-9-14