Figure 121: Mounting Bracket Attached to the Side Panel of EX4300-48MP and EX4300-48MP-S Switches
3. Align the bottom holes in the mounting brackets with the holes on the side panels of the switch chassis.
4. Insert mounting screws into the aligned holes. Tighten the screws by using the Phillips (+) screwdriver.
5. Ensure that the other holes in the mounting brackets are aligned with the holes in the side panels. Insert
a screw in each hole and tighten the screws by using the Phillips (+) screwdriver.
6. Have one person grasp both sides of the switch, lift the switch, and position it in the rack, aligning the
mounting bracket holes with the threaded holes in the rack or cabinet rail. Align the bottom hole in
both the mounting brackets with a hole in each rack rail, making sure the chassis is level. See
Figure 122 on page 358.
Figure 122: Mounting the Switch on Two Posts of a Rack
g020094
Mounting rack
Mounting bracket
358
To Next Page
Loading...
