Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X - Page 108

Table 10: Command Mode Overview (continued)
Exit from ModeAccess to ModeUse of ModeMode Name
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
specify the map-class
frame-relay command.
■
Prompt:
host1(config-map-class)#
■
Specify fragmentation
for a map class.
Map Class Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the map-list
command.
■
Prompt:
host1(config-map-list)#
■
Configure map list
parameters.
Map List Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the parent-group
command.
■
Prompt:
host1(config-parent-group)#
■
Configure an external
parent group.
Parent Group
Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
To create a policy list,
from Global
Configuration mode use
the policy-list
command and identify
the type of policy list.
■
Prompt:
host1(config-policy-list)#
■
Configure policy lists.Policy List Configuration
■
Use the exit command twice to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration Mode,
use the policy-list
command to create or
access a policy list.
From Policy List
Configuration Mode,
use the parent-group
command.
■
Prompt:
host1(config-policy-l
ist-parent-group)#
■
Configure an internal
parent group in a
hierarchy.
Policy List Parent Group
Configuration
78 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide