Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

Table 10: Command Mode Overview (continued)
Exit from ModeAccess to ModeUse of ModeMode Name
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the
policy-parameter
command.
■
Prompt:
host1(config-policy-parameter)#
■
Configure a policy
parameter.
Policy Parameter
Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the
pppoe-service-name-table
command, and specify
the alphanumeric name
of the PPPoE service
name table.
■
Prompt:
host1(config-pppoe-service-
name-table)#
■
Configure services for
a PPPoE service name
table.
PPPoE Service Name
Table Configuration
■
Use the disable command to
return to User Exec mode.
■
Use the exit command to log
out of the CLI.
■
Use the configure command to
enter Global Configuration
mode.
■
From User Exec mode,
use the enable
command.
■
Prompt:
host1#
■
Show system
information.
■
Set operating
parameters.
■
Access Global
Configuration mode.
Privileged Exec
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the profile
command.
■
Prompt:
host1(config-profile)#
■
Configure profiles.Profile Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the
qos-interface-set
command.
■
Prompt:
host1(config-qos-
interface-set)#
■
Configure QoS
interface sets.
QoS Interface Set
Configuration
Accessing Command Modes ■ 79
Chapter 2: Command-Line Interface