Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X - Page 110

Table 10: Command Mode Overview (continued)
Exit from ModeAccess to ModeUse of ModeMode Name
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the
qos-interface-superset
command.
■
Prompt:
host1(config-qos-
interface-superet)#
■
Configure QoS
interface supersets.
QoS Interface Superet
Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the
qos-parameter-define
command.
■
Prompt:
host1(config-qos-
parameter-define)#
■
Configure QoS
parameter definitions.
QoS Parameter
Definition Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the qos-profile
command.
■
Prompt:
host1(config-qos-profile)#
■
Configure QoS profiles.QoS Profile
Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the
qos-shared-shaper-control
command.
■
Prompt:
host1(config-qos-shar
ed-shaper-control)#
■
Configure variables
within the simple
shared shaper
algorithm.
QoS Shared Shaper
Control Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the queue-profile
command.
■
Prompt:
host1(config-queue)#
■
Configure queue
profiles.
Queue Profile
Configuration
80 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide