Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X - Page 111

Table 10: Command Mode Overview (continued)
Exit from ModeAccess to ModeUse of ModeMode Name
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the radius server
command.
■
Prompt:
host1(config-radius)#
■
Configure Broadband
Remote Access Server
(B-RAS) parameters.
RADIUS Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the radius relay
server command.
■
Prompt:
host1(config-radius-relay)#
■
Configure RADIUS
relay server
parameters.
RADIUS Relay
Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
To create an IP rate
limit profile, from
Global Configuration
mode use the ip
rate-limit-profile
command.
■
To create an L2TP rate
limit profile, from
Global Configuration
mode use the l2tp
rate-limit-profile
command.
■
Prompt:
host1(config-rate-limit-
profile)#
■
Configure an IP or
L2TP rate limit
parameters.
Rate Limit
Profile Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the redundancy
command.
■
Prompt:
host1(config-redundancy)#
■
Configure high
availability (stateful
SRP switchover).
Redundancy
Configuration
■
Use the exit command twice to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Router
Configuration mode,
use the
remote-neighbor
command.
■
Prompt:
host1(config-router-rn)#
■
Configure remote
neighbor parameters
for OSPF, PIM, or RIP.
Remote Neighbor
Configuration
Accessing Command Modes ■ 81
Chapter 2: Command-Line Interface