Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X - Page 112

Table 10: Command Mode Overview (continued)
Exit from ModeAccess to ModeUse of ModeMode Name
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the route-map
command.
■
Prompt:
host1(config-route-map)#
■
Configure routing
tables and source and
destination
information.
Route Map Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
specify a routing
protocol with the router
command.
■
Prompt:
host1(config-router)#
■
Configure a routing
protocol.
Router Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the mpls rsvp
profile command.
■
Prompt:
host1(config-rsvp)#
■
Configure an RSVP
profile.
RSVP Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the rtr command.
■
Prompt:
host1(config-rtr)#
■
Configure RTR
parameters.
RTR Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
menu.
■
From Global
Configuration mode,
use the
scheduler-profile
command.
■
Prompt:
host1(config-scheduler-
profile)#
■
Configure shaping
parameters.
■
Configure scheduler
profiles.
Scheduler Profile
Configuration
82 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide