Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X - Page 113

Table 10: Command Mode Overview (continued)
Exit from ModeAccess to ModeUse of ModeMode Name
■
Use the exit command twice to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the
service-management
service-session-profile
command.
■
Prompt:
host1(config-service-session-
profile)#
■
Configure attributes for
Service Manager
service session profiles.
Service Session Profile
Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
menu.
■
From Global
Configuration mode,
use the snmp-server
management-event
command.
■
Prompt:
host1(config-mgmtevent)#
■
Configure SNMP
events.
SNMP Event Manager
Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
menu.
■
From Global
Configuration mode,
use the
statistics-profile
command.
■
Prompt:
host1(config-statistics-
profile)#
■
Configure statistics
profiles.
Statistics Profile
Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the interface
command and identify
the interface
(slot/port.subinterface).
■
Prompt:
host1(config-subif)#
■
Configure multiple
virtual interfaces on a
single physical
interface.
Subinterface
Configuration
Accessing Command Modes ■ 83
Chapter 2: Command-Line Interface